3116-4527-0001

Servo Extension via CAT6 (Receiving Board), 3116-4527-0001

£13.78 £11.48

This board takes a servo signal sent over a CAT6 cable and breaks it out to servo compatible TJC8 pins.

Or

This Receiving Board is the counterpart to the Sending Board (3116-2745-0001)

COMPATIBILITY

Ethernet Cables: While CAT6 is the recommeded cable, the RJ45 connector this Boosted Servo Extension uses is also compatible with CAT5, CAT5e, CAT6a, and CAT8 cables.

Servos: This Boosted Servo Extension is compatible with any servo which uses a PWM signal. This is just about any servo in the hobby or small-medium robotics industries.

Actobotics Electronics: While this Boosted Servo Extension uses CAT6, it utilizes a newer protocol than the Actobotics CAT6 boards (605102, 605103, 902MSD) making them incompatible with each other.

Weight Board = 11.3g Board with case and hardware - 20.4g
Recommended Voltage Range 6V -15V
Max Voltage Range 3.3v - 18V
Signal Channels 4
Max Current (When powered at Receiving Board) 16A Total (4A per Channel)
Max current over CAT6 (When powered at Sending Board) 4A Total
Servo compatibility Analog & Digital
Maximum Recommended Ethernet Cable Length 100ft (30M)
Power Compatibility TJC8, XT30, 3mm Solder Holes